Replacing old drafty windows on your home is a great way to save money on rising energy bills, along with helping to modernize the property’s appearance. Windows are available for purchase at most any local or big box hardware store, lumber yard, or contractor supply center. You should certainly shop for the best price, but always keep in mind that quality counts. If you buy the least expensive window chances are it will cost you in the long run. You do not need to spend your hard earned money on the most expensive choice, the middle of the road models are typically the smartest way to go.
Many homeowners hire professional contractors to install windows, however this is a project that most people can do themselves by following these three (3) simple steps.
Step 1: Measure twice and install once.
It is extremely important that you accurately measure the size for each window that you plan to install. Performing this simple task will save you a lot of time and aggravation. Your window(s) will go in much easier, and fit far better.
Please note: Take all of your measurements from the inside of your home instead of the exterior. Not only is the measurement more accurate that way, you can avoid climbing extension ladders.
Calculate the window height by measuring down from the top of the sill to the bottom of the head jamb. Take two measurements in order to insure accuracy.
Calculate the window width by measuring from the inside of the left jamb to the inside of the right jamb. Once again, measure twice in order to insure accuracy.
Step 2: Remove Your Old Window(s)
New windows are manufactured to fit into your existing window frames, so technically you will only need to remove the old window sashes, along with the parting bead, and inside window stop.
Please note: Similar to measuring from inside of your home instead of the exterior, it is easier and safer to install the new window(s) from inside of your home.
The first thing to do is remove the inside stop pieces. Do this very carefully because you will be using them again when you install the new window(s). Then take off the inside sash, and slide the outside sash to the bottom of the window frame.
Remove and dispose of the parting beads. Next, eliminate the outside sash in the same manner as the inside sash. You need to leave the exterior stop in place, as it will secure the new windows.
Step 3: Install your brand new window(s)
Now comes the fun part. You get to install your shiny new windows!
The first thing you need to do is lay down a bead of caulk along the outside stop of the window jambs, then caulk and install the sill angle.
Center both the top and bottom sashes in the window frame. Slide the bumper stops toward the center of the window frame. There are a total of four mounting holes located on the side window jambs. Make sure they are visible before proceeding. Caulk the top of the header after positioning it on top of the window.
Place the window in the frame, and use a level to ensure that it is sitting square. Shim as needed in order to properly square if needed. Install the four mounting screws into the side jambs.
If there is a small space between the top of the new window and the old frame, than seal it. Test out the top and bottom sashes, by raising and lowering them, in order to ensure that they are working properly. If they do not move smoothly, use the built in adjustment screws to tweak the window frame. Last but not least, caulk the inside of the new window, and reinstall the window stops.
Enjoy your new window(s).Read More
Remodeling your living room can be more fun. Although, the process can be a bit exhausting, you should be well prepared in advance to avoid any surprises. One of the best things about the DIY tips on how to remodel your living room is that it is cost effective. You are able to save on the remodeling costs. Moreover, you are able to remodel the place to suit your taste and preference.
Therefore, with these 5 more DIY tips on how to remodel your living room, you should be able to apply just in case you are planning to do a makeover of your living room.
- Choosing the New Design for Your Living Room
This is the most crucial step of your DIY remodeling tips. Take your time to choose what suits you best. This includes things like the wall paint color, the color of your furniture, the size of your living room, the size of the furniture. With this in mind, you will be able to know how to implement your new DIY design. You can even make sketches of how you envision your living room to look after the remodeling process.
- Clearing of the Room
This is done to create space in the living room. Once you have removed everything from the living area, you can now start the next step. Here, you will require help to move the furniture from the room because some of them might be heavy.
- Painting the Walls and Fixing of the Lightings
Next step is wall painting. At this stage, you have already chosen the color that you want for your living room. Before you start painting, ensure that the walls are smooth. This is to make the wall painting to appear flawless. Additionally, ensure that you get experienced professionals to do the lighting fixings. This is if you need to change the lights fixture, although it is not necessary. The experts will handle all the wiring, electrical cables, and chandelier fixing.
- Remodeling of the Floor and Ceiling
This involves changing of the floors design. This is can either be done by carpeting, putting ceramic tiles, or the wooden tiles. Always make sure that the flooring matches with the paint on the walls. Any contrast or color clashing can make the whole remodeling look like a mess. This will make your DIY remodeling a flop, which is not what you want.
With the ceiling, ensure that it is high enough. This is to ensure safety and comfort of those visiting and using the living room. For instance, if the ceiling is too low, then chances are that it might be very uncomfortable for a tall person to be in the room. You do not want your living room to feel small, do you?
- Arranging of the Furniture
At this stage, you can arrange the furniture that you have selected. Make sure you arrange them in such a way to create an impression of a large and spacious room. Ensure your windows have well fitting curtains or blinders that match the color of the room. When arranging the furniture, avoid placing your sofa set at the window. This is to create space and to bring more light into the room.
Finally, you can enhance the look of your living room by adding some plants and flowers. This will bring ambiance to the room. Therefore, with these 5 more DIY tips on how to remodel your living room, you should be able to redesigned your living room to your taste anytime.
It goes without doubt that color enhances attitude. The way your house is painted directly affects your appreciation. You can do it yourself or hire contractors to it for you. Since you are not an expert, it is good to consider a number of factors before embarking on your painting. In this article, we are going to focus on the tips that will make sure you produce your best.
- Seek advice from experts
It ii highly recommended you seek advice from experts at your paint shop on how to do painting. The advice is normally free and the experts are always willing to give it. Whether you are buying the paints and the painting equipment at that shop or not, you will still get the technical help. The end results of your painting will greatly depend on the advice you are given by a professional.
- Prepare your surface
This is a universal tip. If you did not know this, now you know. You will not get a good paint finish if you do not adequately prepare your wall. When you go to buy the paint and equipment, ask for surface preparation materials. You should expect to must buy sand paper, plastic filler for plastic walls and timber fillers. Before you start applying paint, make sure the surface is clean and does not have rough hilly surfaces. The surface should also be firm. Well-prepared surfaces offer a better and long lasting finish results.
- Buy quality paint and painting equipment
Experts may have a way of producing quality and fine finish without necessarily using quality expensive paint and painting equipment, but since it is you doing it yourself, you will need to buy quality paint and painting equipment like the brush so as quality of work is not compromised. There is a very wide range of equipment and paint on the market whose quality majorly depends on the price; few extra dollars will gives you better paint and equipment.
- Choose wisely between oil and water paints
When doing your painting on your own, it is very important you choose wisely between oil and water paints. The two both have pros and cons which you need to know so that you can correctly prioritize one over the other. Oil paints are hard to clean when they spill. They are also very hard to apply. However, these kind of paint results in a better finish when compared to water based paints and the painting is more durable.
On the other hand, water based paints are easy to clean when they spill and also the equipment used to paint can be cleaned with easy, they are also easy to apply.
- Have a painting plan and discuss it with your family members
You should do base your painting style and pattern on random thoughts. Also, consult your family members on the color they would like you to paint the house.
- Clearly distinct between painting and decorating
Many people make a mistake of trying to decorate while painting. First finish painting the whole house and then look decide on the necessary decorations. Remember to remove or cover your furniture well when doing decoration.
It is important to think any practical way when planning any type of home improvement project in the future. Practical projects are vastly improved for us, allowing us to relax and take as much time as required while we do them. You can be practical starting with the measure of cash you have to spend and spending just what you can bear. Repairs typically should be done on the house on the off chance that it is no less than 20 years of age. Spending cash on your house when it needs repairs will always save you cash opposed to waiting for things to deteriorate in the future. Here are three exceptionally practical home improvement decisions that may require help from others to consider.
One of the first things you can do to prevent potential problems is to search for water harm. This can happen near your window replacement winnipeg. It doesn’t make a difference if your house is more established or completely new, water harm may happen. Be that as it may, for more seasoned homes, doing this is almost a most given the age. In the event that possible, do your repairs during the day when it is warm and sunny. Light shining passing through storm runners it’s a clear sign on that water harm may happen. Darkened wood on near the sill it’s a clear sign on harm that already has been finished. The best thing to use is open air caulk that can prevent future leaks from happening.
If you look in your electrical panel, you may see Buss fuses. In more up to date homes, you will see circuit breakers in your electrical panels. These Buss fuses won’t be there. It is not a problem on the off chance that you have fuses instead of circuit breakers. Times change, and moving to cutting edge electrical switch panels is where everybody is going. For safety reasons, you may need to consider using a qualified electrician that can carry out the employment rapidly. Your CB panel ought to be installed properly, the length of it matches the current rating that your house is supposed to have.
Infra red sweeps cost a great deal of cash, yet in the event that you have the money, you can do this for your home to find out about your insulation. The cost of the equipment to do the sweep is high so the proprietors charge quite a bit to do the process. The camera won’t be affected by the temperature of your house, or the season in which it is used. In any case, it will tell you about your insulation. To get the best pictures, hold up till its dull. On the off chance that you don’t have time around evening time, daytime imagery can be taken. Using the latest technology on infra red , thermal imagery will demonstrate to one where leaks in once house as in regard to be on heat.
Always be aware that each home improvement project that you do should be focused upon safety. What becomes hazardous is when individuals attempt to do things that they have no idea about. Doing home improvement projects, without the ability or understanding of how to do the project, can lead to your demise. So always take as much time as required when embarking on any progressions that involve electricity or the expansion of anything that can change load characteristics.